![]() Slide the required insert label into the pocket to provide a description of the switch function.The fascia label is provided with a slide-in label pocket for a user text description.Use Level 3 panel access or the PC Tool to program the required function for each switch.Fold up any extra cable neatly and apply a tie-wrap to hold in place.The leads are a common length suitable for installation of the switch in any Route the wiring as shown below and install the plug on the connector for the required switch.Insert the key-switch mechanism and tighten the nut.Use a sharp knife to cut through the fascia label using the aperture profile as a template. ![]() To install a key switch, follow these easy steps: These are pre-wired with the appropriate 2-pin connector. Optional key switches (volt-free) are available to be mounted on the MxPro 5 panel fascia plate. The options include results for zone rule, input event and logic statement programming. These can be confirmed by selecting a loop input device from the left-hand selection window, with results for the output device that will operate shown in the right-hand window. The same applies for inputs driving outputs. The right-hand window will automatically display the input event results that have been assigned to drive that device. Once in the “Cause and Effect Check” option, you can confirm that the output programming is correct by selecting a loop device from the left-hand window. The results displayed will vary depending whether an input or output is selected as the source object. This allows you to confirm the outcome of an individual device activation. ![]() If so, you can use the “Cause and Effect Check” option that’s built into our programming software. Do you want confirmation that your programming is correct when using our configuration software (PC-Net-003)? ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |